 ONE FLOPPY DRIVE INSTALLATION INSTRUCTIONS
 1.  Insert a DOS diskette into drive A.
 2.  Type the command "SYS B:".
 3.  Strike the enter key.
 4.  When prompted to insert a diskette for drive B:, remove the DOS
     disk and install the ADVANCED SETUP+ DISKETTE.
 5.  Strike the enter key.
 6.  When the computer asks you to insert a diskette for dirve A:,
     remove the ADVANCED SETUP+ DISKETTE and reinsert your copy of DOS.
 7.  Strike the enter key.
 8.  Now, when the computer asks you to insert a diskette for drive B:, again
     remove the DOS diskette and reinsert the ADVANCED SETUP+ DISKETTE.
 9.  Strike the enter key.
 * The screen should now display
      System Transferred
 10. After this message, place your copy of DOS back into drive A: and
     issue the command  "COPY COMMAND.COM B:".
 11. Strike the enter key.
 12. Again, strike the enter key.
 13. For the last time, swap the DOS diskette that is in drive A:, with
     the ADVANCED SETUP+ DISKETTE.
 14. Strike the enter key.
* At this point, you should have "A>" displayed on your screen.
